Instructions to reset drum and toner Brother HL-2240D printer

Instructions to reset drum and toner Brother HL-2240D printer

Saturday - 12/04/2021 10:12
The Brother 2240D is a printer with an ink chip attached. Therefore, when the number of prints reaches the chip limit, the toner or drum error yellow light will light up. At this point, you must replace the toner cartridge or a new drum.
However to save, we can reset them, by:

Reset Drum Brother 2240D

- Turn off the printer
- Open the front cover of the printer
- Press and hold the GO button and turn on power the printer
- Wait a few seconds ...
- Release the GO button
- Wait a few seconds ...
- Press and hold the GO button again

Wait a few seconds, then close the front cover of the printer and restart the printer.
 

Reset toner Brother 2240D

- Turn off the printer
- Open the front cover of the printer
- Press and hold the GO button and then power on the printer
- The lights will light up, wait a few seconds, release the GO button
- Wait a few seconds, press the GO button 2 times
- The lights will light up, wait a few seconds, press GO button 5 times
- Wait a few seconds, close the printer cover, the Ready light will light up.
Then restart your printer and now your printer is working normally.

This guide is applicable to Brother HL-2130, Brother HL-2140, Brother HL-2240, Brother HL-2240dn, Brother HL-2250, Brother HL-2250dn printer models.

  Reader Comments

Security Code   
You did not use the site, Click here to remain logged. Timeout: 60 second